![]() So, groups at 100 won't be the best representation. I still want to do an accuracy test for you, but I only have a red dot on my AR. He probably won't charge me, so I'll likely have him throw it on tomorrow. ![]() So, I have to pick one up or will just have my gunsmith do it. I don't have an action rod or the proper vice blocks. Did you end up picking up some of the fusion from PSA? I grabbed a couple hundred at those prices. We had the discussion on the Fusion and CLUB ammo accuracy. Thanks!As far as alignment goes, there is no 'true' top and bottom due to it's design, however, generally the hole for permanent pinning goes on the bottom and the logo on top to be more aesthetically pleasing.ĮTA: Feel free to post about your experiences with the SI J-Comp and rifle in general as well.Will do! I thought your name sounded familiar. If nothing else, anyone have experience with these breaks? Do they seem to hold up over time? Just figured it was worth checking beforehand. There is a "SI" logo on one side of the Break, so I'll likely orient it with that on the top side. But, I know some breaks cut the chambers with more/less material on one side vs another. My main question would be, is there a Top and Bottom? I know the "ports/chambers" should be horizontal to the ground. I know a muzzle break installation is a Novice level alteration, but was wondering if anyone had instructions for this particular Break lying around. However, it did not come with instructions (even though it was pictured on the website). Best bang for the buck that I could find, and I was gifted one for Christmas. I know this may be a very basic question, but would rather be laughed at for asking then waste the only crush washer that came with my new Muzzle device.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |